Audio Setup

[L2UKS]

Ok people the last time i did this it didnt work properly therfore im trying again.

Basically i am setting up an after market cd player with a 4 channel jbl amp. Along with 2 6x9s and a 12" sub.

From my last attempt i remember most of it therefore on the pic i composed the blue wires are what i knw is correct (please correct em if this is wrong).

The problem areas are highlighted in red and the red wires i don't exactly know where to go.

I hope someone is able to help soon as i want it done in the morning as got work in the evening.

Dont need a pic but good explanation will help!

Thanks

http://thegreenzapscam.com/untitled.JPG

[sicky]

u put the + for the left 6x9 on the left + and the - on the left -, and vice versa for the right 6x9, then u put the sub + on the + for the right, and the sub - on the - for the left

[ka$h]

As sicky's post, but, not sure, check your manual and you may need to link the R- & L+ on the sub as well. As for the HP, LP and flat settings, LP for which has the sub on as this blocks all upper frequencies and lets the Low ones Pass. I'd say Flat for the Speakers as they are full range.

K

[L2UKS]

Will look for the manual, it was a bit difficult to see what to do in it,but will pull it out and have a proper look with your advice in mind.

Thanks