running wires down the side

[Jason]

i have ran 4 awg down the side, but i have put it right next to the OEM wirings looms

when u take the sill off, the is a black plastic channel where a lot of OEM loom goes thru, i out my wire thru the channel, will i get an interference with other bits? if u get what i mean

[BarinaSXIpurthOZ]

No

[BarinaSXIpurthOZ]

how do u think every one else dose it ?

[matt_fallon]

you cant run the RCA and power down the same side as you'll get interferiance!

[Coops]

I did it exactly the same and its fine mate.

Dont worry bout it ! :thumbs:

[BarinaSXIpurthOZ]

Power down the Passanger side and the RCAs down the Drivers

[D4VO J]

you cant run the RCA and power down the same side as you'll get interferiance!

you wont, its such a load of crap

[Jason]

i didnt mean thaT ffs, im onabout the OEM wiring that runs from the relays and fuses, there is a square tube where all that goes from the sills, i have uncliped the tube and placed it inside with all the OEM relay and fused wires, rather than put it on the outside as i cant clip the sill down

[D4VO J]

i didnt mean thaT ffs, im onabout the OEM wiring that runs from the relays and fuses, there is a square tube where all that goes from the sills, i have uncliped the tube and placed it inside with all the OEM relay and fused wires, rather than put it on the outside as i cant clip the sill down

thats what everyone does or u cant get the sills down.
those wires carry barely any current at all, basically just wiring for rear lights and boot lights, etc, nothing that will interfere

[Nick913]

hw do u get the carpeting up 2 hide the wires?? coz i got a load of wires on the floor atm

[Coops]

hw do u get the carpeting up 2 hide the wires?? coz i got a load of wires on the floor atm
You dont need to, just take the sills up and put it under there ! :P

[Jason]

lift off the sills and u will see 2 square tubes, unclip them and place all your wiring in there along with the cars original wiring looms