[Chazspaz49]

I have a 2006 corsa c design 1.2 xep and want to fit cruise control I ha e bought the indicator switch with the buttons on it and I have opcom for programming but don't know what I need to do next for how to fit it. If someone knows a step by step than I would much appreciate it thanks in advance

 

[marks152]

I fitted it to my z10xep. You need the clutch switch too. I had the wires for the stalk installed but had to add the clutch switch wiring. Once the stalk and switch was connected it just need activation in the ecu and bcm.

 

[Chazspaz49]

I fitted it to my z10xep. You need the clutch switch too. I had the wires for the stalk installed but had to add the clutch switch wiring. Once the stalk and switch was connected it just need activation in the ecu and bcm.

Oh OK that's good I imagine that I probably have the wiring already there. But as far as the clutch switch goes I know I can buy them for about £10 on ebay but HOW AND WHERE do I fit it. Thanks.

 

[marks152]

It fits to the clutch pedal bracket. Its a bit fiddly but not too bad.

 

[Chazspaz49]

It fits to the clutch pedal bracket. Its a bit fiddly but not too bad.

I have bought and fitted the indicator stalk. And bought the clutch switch but can't find the place to fit it. Do I have to remove any panels for other bits to get to it?

 

[marks152]

From memory i just removed the lower dash panel which gave me access albeit tight access.