[TIMBO1]

just bought some new 16" but unlike most 16's that have a width of 6.5 inches these are actually 7 inch. to compensate this the offset is 45. My coilies re wound down roughly 60/70mm at the back and 50/60 at the front, should i be ok keeping the set at this height with them only being 16s still or for the reasons stated will it need to be wound up a bit.

any help much appreciated.

thanks, tim

 

[ChrisSxi]

A bit of trial & error should be fine Drive about, if there's any rubbing, then wind them up a bit :thumbs: If no rubbing, your jammin :dance:

 

[rad_brad]

A bit of trial & error should be fine Drive about, if there's any rubbing, then wind them up a bit :thumbs: If no rubbing, your jammin :dance:

seconded

 

[TIMBO1]

i thought it should be ok but ive never seen 16 with a 7 inch width , obviously deep dish are more but i didnt appreciate that til after i bought them. Really dont want to jack it but oh well. If anyone has got the above size let me know if you had rubbing. Not 17's though as obviously the wheel diameter is bigger.

cheers guys

 

[davey]

you shouldnt get any rubbing. im on 7x15 @ ET28,im about 60mmish on the front and 85ish on the rear. NO rubbing what so ever