how i smoothed my boot

glue a peice of plastic in the boot
P38 easy sand body filler
instead of using the touch up pen like in the guide which doesn't leave it smooth
i masked up around the holes leaving about 0.5mm around the filler and sprayed the boot
leave for 24 hours
t-cut to smooth
polish
done

you could put "corsa" over the hiles like i did at first

but looks so much better with no badges, you can;t see where my holes was

 

Could cheat like my mate did with his, takes badges off and stick 1 or 2ps behind the holes with tigerseal, then fill the holes and paint

 

you could do it with 1p &2p but imo a tigerseal a peice of plastic works better, something like a dvd box worked well for me

 

ok brilliant thank you
what glue should i use to glue in the plastic? and i only need a small piece yeh, not a whole dvd box ?
will i need to snad it down after the filler has dried?
and do i primer? then paint then laquer?

 

i used tigerseal to glue mine in place, but you can use any glue aslong as it will set rock soild.

you only need to cut a strip longer enough to cover both holes

yeah you will need to light sand to smooth to the boot shape,

primer
colur

you can lacquer it, but i found when i did it the new lacquer showed up to much compard to the old lacquer

 

good question chris, id like to know 2

 

this will help

http://www.corsa-c.co.uk/forum/showthread.php?t=175853

i found the result alot better to spray the filler then using a tocuh up kit